wkilc
New Member
New counter, new sink. I cut out the old, glued-PVC trap and decided to go with a easily-removed threaded trap assembly.
New sink is slightly off center to connect the trap directly on the stub out line. Tried a 90-degree elbow and it all lines up perfectly.
Dry-fit photo attached. Is this okay? It's a standard elbow, not a long sweep. The latter would not allow for the alignment I have now. Is the trap-arm length adequate? I am assuming the arm length includes the bend.
There's an atmospheric vent in the wall, so that's why no cheater vent.
Thank you.
New sink is slightly off center to connect the trap directly on the stub out line. Tried a 90-degree elbow and it all lines up perfectly.
Dry-fit photo attached. Is this okay? It's a standard elbow, not a long sweep. The latter would not allow for the alignment I have now. Is the trap-arm length adequate? I am assuming the arm length includes the bend.
There's an atmospheric vent in the wall, so that's why no cheater vent.
Thank you.
Attachments
Last edited:
