chollyred
New Member
Trying to replace a pressure switch on a submersible pump. Wires were pulled loose before I got here.
The pump is 110v and was wired using the end of an extension cord, so 3 wires to the switch. Then the 2 wires to the pump were both wired to the chasis of the switch (ground).
Makes no sense to me.
How should this be wired? Pretty urgent as just before Thanksgiving.
I can be reached at 770-866-8738.
The pump is 110v and was wired using the end of an extension cord, so 3 wires to the switch. Then the 2 wires to the pump were both wired to the chasis of the switch (ground).
Makes no sense to me.
How should this be wired? Pretty urgent as just before Thanksgiving.
I can be reached at 770-866-8738.
