I am still trying to figure out a way to create an on demand hot water recirculating system. I am looking at the Grundfos Modern Comfort UP 10-16 pump. I think the Aquastat feature could be helpful.
1. Can I use the Aquastat without the time on this unit? I would like to just push a button to turn it on then have it go off when the water at the end gets to a certain temperature.
2. Do you know how I can create an on demand system that goes off after the water in the loop gets to a certain temperature or after a set amount of time, say one minute of run time?
1. Can I use the Aquastat without the time on this unit? I would like to just push a button to turn it on then have it go off when the water at the end gets to a certain temperature.
2. Do you know how I can create an on demand system that goes off after the water in the loop gets to a certain temperature or after a set amount of time, say one minute of run time?
