Hot water toilets, Manibloc upside down issue

[kenzieleejardina]

kenzie jardina <[email protected]>

10:48 AM (4 minutes ago)

to customerservice

Hello,

I'm hoping you can help me find a solution. Our issue is that our supply lines enter from the bottom. Our initial manifold (the solid grey) has the lines going correctly, but when it broke and we replaced it with a Manibloc, the lines are now reversed. Everything labeled blue is hot water, and everything red is cold.

In other words, the toilets in the upstairs bathrooms flush with hot water.

We've contacted professionals in the area, but they either say they've never seen anything like this, or that the only solution would be to cut into the walls to re-route the supply lines into the top.

I'm hoping there's an alternative you can help me find. The wall behind the Manibloc is the toilet enclosure, so cutting in to it would mean an extensive remodel. I've tried to find an image of what the inside of the manifold looks like, in the hope that there is an easily switchable configuration if I opened it up, but I've been unsuccessful.

Help please! My butt doesn't need a steam clean. LOL

 

[Twowaxhack]

Reverse the two lines at the bottom that I’ve circled.

A wall full of sharkbites.......what a mess......

 

[kenzieleejardina]

They aren't flexible enough to do that. Is there a flexible attachment I could use?

 

[Twowaxhack]

They aren't flexible enough to do that. Is there a flexible attachment I could use?

Cut the wall open and use poly x pex adapters to make them longer.

Pex and poly is flexible.

 

[kenzieleejardina]

Thank you! I will try that!