Washer drain plumbing using old bathroom fixtures - advice?

Plumbing Forums

Help Support Plumbing Forums:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Mark Cutler

New Member
Joined
Dec 23, 2024
Messages
1
Reaction score
0
Hi all,

I'm looking to install an upstairs laundry room in what is currently the master closet. At some point in the past, this closet used to be the master bathroom. I've opened the wall and confirmed that there is an unused 3-inch drain I can tie into (the drain the toilet used to use). I'm looking to put a washer, dryer, and small utility sink in this room.

Can you all please take a look at my design and let me know if anything should be changed? In particular, I'm wondering about the following:

1. The wall is a double 2x4 with all the plumbing going through "back" wall. I'd like to keep it that way and not touch the front wall even though it isn't load-bearing. To do so, I have to angle the 2-inch horizontal run after the vent. Is there any reason this isn't allowed?

2. For the same reasons, I'm planning to route some existing drain vents around the new plumbing. Is it allowed to use 45 connections below the flood rim as long as the vent stays within 45 degrees of vertical?

Legend:
Yellow - 2in vent pipes
Blue - 1.5in vent pipes
Green - 2in drain pipes
Red - 3in drain pipes

Thank you!
 

Attachments

  • Screenshot 2024-12-14 at 9.44.09 AM.png
    Screenshot 2024-12-14 at 9.44.09 AM.png
    399 KB
  • Screenshot 2024-12-14 at 9.44.52 AM.png
    Screenshot 2024-12-14 at 9.44.52 AM.png
    1.5 MB
  • Screenshot 2024-12-14 at 9.45.58 AM.png
    Screenshot 2024-12-14 at 9.45.58 AM.png
    1.3 MB
  • existing_drains.jpeg
    existing_drains.jpeg
    574.8 KB
Back
Top