Techtanium indirect heater, Anode Rod replacement

[georgewny]

Looking for advice, am just a DIYer.
back in 2018, I had a plumber install a Techtanium indirect hot water heater.
Now fast forward to September 2024, and I just replaced both anode rods and did the first flush on the tank.
Can someone tell me if the picture of the rods look like normal erosion for a6 year old heater?

Also the color of the water from draining was a horrible rust color, see picture. This that normal for never having drained the tank in 6 years?

Thanks for any advice/information.

Regards
George

 

[breplum]

When anode rods are down to nothing, that indicates that they have sacrificed themselves as designed. Your old ones look to have a lot of life left. I have seen similar minimal sacrificial activity before.
Rusty water does indicate internal rusting is obviously occurring (unless you are getting dirty water coming in to the tank). So unless your unit is stainless steel then it is the glass lined steel tank. Steel tank linings can develop micro-cracks in the glass lining (though I thought that the lack of a burner would help with longevity. Those micro-cracks lead to rusting but, that is where the anode should be sacrificing…so maybe someone else knows why so much sediment.

 

[georgewny]

When anode rods are down to nothing, that indicates that they have sacrificed themselves as designed. Your old ones look to have a lot of life left. I have seen similar minimal sacrificial activity before.
Rusty water does indicate internal rusting is obviously occurring (unless you are getting dirty water coming in to the tank). So unless your unit is stainless steel then it is the glass lined steel tank. Steel tank linings can develop micro-cracks in the glass lining (though I thought that the lack of a burner would help with longevity. Those micro-cracks lead to rusting but, that is where the anode should be sacrificing…so maybe someone else knows why so much sediment.

Thanks Breplum
Much appreciated,
I was kind of mortified by how bad a condition the water in the tank was, considering it is an indirect heater.

Couple of positives have come from me taking on changing the anodes...

- I never realized how easy it was to drain the tank, after watching several youtube videos, I just put a small pump in a bucket and drained the heater into the bucket, super simple. Then turned on the water fill to allow several gallons of fresh water into the heater, and drained again. Did that several times till the waste water was clear.

- Anode rods came out with minimal force, very easy to change them. It was harder to find a company that actually stocked them vs how easy it was to replace them.

- Since I've feel I know a good method of draining, I'll do it once a year going forward.

I want to thank all the professionals, between what I have read in forums and seen from YouTube.
It enabled me to finally do these maintenance tasks with little to no fear.

Regards
George

 

[ambilobe]

Looking for advice, am just a DIYer.
back in 2018, I had a plumber install a Techtanium indirect hot water heater.
Now fast forward to September 2024, and I just replaced both anode rods and did the first flush on the tank.
Can someone tell me if the picture of the rods look like normal erosion for a6 year old heater?

Also the color of the water from draining was a horrible rust color, see picture. This that normal for never having drained the tank in 6 years?

Thanks for any advice/information.

Regards
George

I am three years into my TT79, and was going to drain it this weekend and check the anode rods. Do you turn off the boiler and power to the water heater before draining? The manual doesn't specify, but would seem to make sense.

Do you use a torque power drill to remove the anode rods?

Thanks