Santinary tee higher than dishwasher inlet on tailpiece....

[branimal]

Can I solve this with a high loop on the dishwasher drain tube?

 

[Rossando]

You have a few options.
1. Cut into the wall and lower the tee.
2. Get a low profile basket strainer.
3. Reverse the p-trap to make it work(not advised)

 

[Twowaxhack]

Get a sink that’s not so deep and get a lower profile sink basket drain.

 

[branimal]

You have a few options.
1. Cut into the wall and lower the tee.
2. Get a low profile basket strainer.
3. Reverse the p-trap to make it work(not advised)

1. Right below the santee is a 90 el that runs to a drain pipe to the left.
2. yes I can do that
3. I read that the j-bend is reversible. Meaning the long leg can be installed on either side.

Out of interest, if i left current basket strainer in place, what issues would arise? I guess the water line would always be at the bottom of the weir of the trap arm. maybe leading to leaks at the dishwasher inlet.

 

[branimal]

Get a sink that’s not so deep and get a lower profile sink basket drain.

Can't swap the sink. My quartz guy already cut the stone.

 

[Rossando]

Your best bet it to change the basket...from what you stated above.

 

[MicEd69]

By various codes, the maximum trap seal depth is 4". By the picture, I'm guessing that you would be over that without changing out the basket strainer.