backwater valve

Thread starter ghildebrandt
Start date Dec 4, 2014

Help Support Plumbing Forums:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

ghildebrandt

New Member

Dec 4, 2014

I would like to install a backwater valve in a 4-inch cast iron sewer pipe. I would like to know the the top of the line valve to use for this. Any help would be most appreciated.

You must log in or register to reply here.

Facebook X (Twitter) Reddit Pinterest Tumblr WhatsApp Email Link

Latest posts

S
Toilet supply stem replacement problem.
- Latest: spiget1
- Yesterday at 10:41 PM
General Plumbing Help
R
Trying to reduce pressure going into my radiant floor heating via my Polaris water heater
- Latest: Radiant Floor Heating
- Yesterday at 9:43 PM
Water Heaters & Softeners
R
Adapting to a flexible softener drain line.
- Latest: Rgerhardt61
- Yesterday at 8:45 PM
Water Heaters & Softeners
T
3/4 inch PEX A pipe through Cinder Block
- Latest: Twowaxhack
- Yesterday at 6:03 PM
Plumbing Products
D
What temp should this be
- Latest: dinows
- Yesterday at 2:56 PM
General Plumbing Help
Water Treatment Recharge Question
- Latest: ktozzi
- Yesterday at 12:24 PM
Water Heaters & Softeners
M
Cheater vent placement
- Latest: MicEd69
- Yesterday at 9:28 AM
General Plumbing Help
Can I place a brass bibb on an iron pipe?
- Latest: Ludington
- Yesterday at 8:52 AM
General Plumbing Help

Back

Top

backwater valve

Help Support Plumbing Forums:

ghildebrandt

New Member

Latest posts

Join the conversation!

Join today and get all the highlights of this community direct to your inbox. It's FREE!