standpipe

Plumbing Forums

Help Support Plumbing Forums:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. Q

    Adding Vent to Laundry Standpipe

    Hi, I have a restricted trap below my laundry standpipe that can no longer handle the spin cycle output of my washing machine. It is the original installation from 1962; a 2" cast iron pipe goes below the concrete floor to a buried trap. Several times over the last 15 years I was able to...
  2. J

    Draining sink & washer to same standpipe?

    All, thanks in advance for the help. I’d like to add a utility sink near my washer. Currently there is one standpipe, shown in the picture and it does not vent through the roof, also no trap. Is it a big deal to drain both a sink and washer into the pipe? I planned to expand left [pic] for the...
  3. C

    Troubleshooting Main Drainpipe Leakage & Possible Washer Standpipe Design Issue(s)

    I would like to get your recommendations on troubleshooting and fixing main drainpipe leakage and possible washer standpipe design issue(s). Background: One of our younger relatives remodeled our laundry room in our Salt Lake City, UT basement a couple of years ago and we have had some issues...
  4. J

    Standing Drain or "Standpipe" Pressure issue?

    Hello, My block was recently pummeled by 3.5" of rain in less than two hours. There is a 45" standpipe in the only floor drain in the basement. My neighbors had sewage backup, i did not because of the standpipe. I might have gotten it worse - it seems as though a crack in the floor started...
  5. P

    Standpipes and laundry sink

    I'm going to replace an old concrete double width laundry tub with a newer plastic setup. The existing has no standpipes. Instead, the washing machine is hooked over one end of the tub and the opposite side of the tub has the water softener drain. Since these drains are a good 5 ft. apart I'm...
Back
Top