access panel

Plumbing Forums

Help Support Plumbing Forums:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. L

    If I move drain clear-out from floor to wall, I'm afraid augur will get stuck on seam of 90, as it did outside when using the round/spiral hole cutter

    If the bend was 45 degrees it might be okay, but with a 90 degree bend the coil/snake on a 100' augur is under so much tension that no matter how you move it there is always tension pushing the cutter into the 2 mm ridge/seam where a straight drain meets the 90, so the augur can't be pulled back...
  2. G

    Exterior access panel

    Are exterior access panels behind a shower valve not very common? I'm not seeing many examples of them in a bit of searching. Something like this - http://czkatalog.info/plumbing-access-panel/ Both of my showers back up to the same exterior wall, and it's basically my utility wall on the...
Back
Top